VT200 Evolv DNA200 Box Mod, 200W (VW + Temperature Control)
Out of stock
Malmö: Bergsgatan 14
Lund: Lilla Fiskaregatan 8
VT200 is a temperature controlled 200W box mod from Hcigar that uses the new and impressing DNA200 chip from Evolv.
Featuring the new Evolv DNA200 chip set, this 200 Watt capable board is the heartbeat of the last regulated mod you'll ever need! Featuring a full set of features including variable wattage from 1 Watt to 200 Watts of output power, temperature control, and a fully integrated software suite that allows the user to connect the device to a computer for full customization of all features and display screen for the unit!
Powered by an 11.1V 1300mAh 30C lithium-polymer pack, this battery outputs an equivalent of approximately 4200mAh compared to what we're used to with 18650 batteries! This battery pack is included with the device, is replaceable, and may be available for additional purchase at a later date. This high strength yet comfortable to hold box mod is designed with a metal frame of this mod, with magnetically attached side panels for easy access to the battery. The Evolv DNA200 regulated variable wattage power control board has temperature control features through voltage step up/down topology.
A mod that can control the temperature will significantly save both battery and e-juice but make dry hits impossible to get. Remember that you need to have a coil based on nickel (ni200) or titanium (Ti) to regulate the temperature of your vape. With VT200 you can set a maximum temperature as the wire in your coil heats up to. When the coil have reached the set temperature the Evolv-chip will lower the power (watts) so that the temperature does not exceed the set limit.
Regulation of the temperature provides a variety of benefits:
- No more dry hits!
- No more burnt wicks, even when your tank is bone dry!
- One way to literally be able vape to the last drop.
When VT200 is used with temperature control the watts work as "gas" so to speak. The watts simply dictates how fast your coil reaches the temperature set as a maximum. VT200 can regulate the watts up to 200W and can maintain a consistent effect regardless of the charging status of your battery.
Voltage step down:
A new technology that is included in Evolvs DNA chip that allows the device to be powered by volts under the natural state for the battery. In practice, this means that you can build a coil with a very low resistance (ohms) while at the same time can run it on a very low wattage. Low watt combined with an extremely low ohms means that the volts will be forced down to whats natural for the battery. This is a welcomed feature for those times when you want to take a break from chasing clouds at high watts and unwind with a vape on low wattage with your coil at low ohms.
VT200 has on one side an OLED screen which shows set watts, atomizerns resistance (ohms), the remaining amount of battery, voltage and temperature. The center pin is spring based and of solid copper for maximum electrical conductivity. Above the OLED screen is the button to activate the atomizer and two buttons to raise and lower the ohms. The battery lid is held with screws. You charge the VT200 via the built-in micro-USB port and an LED indicator changes from red to green light when the battery is fully charged. The threading is 510.
NOTE: Never discharge your DNA200 battery completely! If a LiPo-batteri is completely drained it wont be charged. If this would be the case then you will have to do a Battery Recovery in the Escribe software. Each time a Battery Recovery is done you'll get a slight imbalance in the battery that eventually will lead to one or more dead cells.
- Height: 95mm
- Width: 54mm
- Depth: 25mm
- Spring Loaded 510 Contact Pin
- Uses the DNA 200 Chip by Evolv
- Large OLED Display (0.91")
- Operating Wattage: 1.0 to 200.0 W
- Resistance Range (Standard Coil): 0.1 Ohms to 2.0 Ohms
- Resistance Range (Temperature Control Coil): 0.08 Ohms to 1.0 Ohms
- Operating Temperature Control: 200F to 600F 100C to 300C
- Utilizes 3S Li-po 1300 mAh battery
- Low Voltage Protection
- Low Resistance Protection
- Short Circuit Protection
- High Temperature Protection
- Can be charged via USB (Micro USB Cable included)
- 1 x HCigar - VT200 Evolv DNA200 Box Mod, 200W (VW + Temperature Control)
- 1 x Micro USB- cable
- 1 x 3S Li-po 1300mAh battery
- 1 x Manual
- 1 x Box
- 1 x Warranty Card
1. Hcigar having trouble getting enough chip sets for the production, so it'll be delayed until earliest 19/10.
2. The 510 connection is gold plated stainless steel. /N